Monitor Installation - golmar Rock Serie Manuel D'installation

48
F
ix the monitor connector to the wall.
Do not install the device near heat sources, in places with dust or fumes.
Install the monitor directly on the wall, by drilling four holes whose
diameter is 6mm and by using the screws and wallplugs supplied.
The upper part of the connector must be positioned
at a height of 1,60m from the ground.
The minimum distance between the connector sides
and any object must be 5 cm.
P
osition the monitor.
Close the monitor like a book, by pressing its
right side towards the fixing pins of the
connector until you hear a "click".
If you need to remove the monitor after it has been
installed, press the fixing pin of the connector
by means of a flat screwdriver. Once the monitor
has been released, open it like a book and separate
it from the connector. Pay attention while
carrying out this operation: the monitor could fall.

MONITOR INSTALLATION

Put the monitor in a perpendicular position
to the connector, so that the holes on the
monitor base and the fixing pins of the
connector coincide, as shown in the
picture.