golmar Rock Serie Manuel D'installation page 53

52
This device can work as a partial doorpanel in building complexes with shared entrances . In this
kind of systems, each partial doorpanel must be programmed with a different backbone code
so that shared entrances recognize which is the partial doorpanel they have to call.
To carry out this operation, do as follows.
NOTE: For this type of installation, please contact the technical trade department of
Golmar.
B
ackbone code programming.
golmar
Find the configuration microswitch located in the rear part of the
detached house doorpanel and set number 5 to ON. Both
doorpanels will produce tones to indicate that program mode is
enabled. The coded doorpanel will display the "PROGRAM"
message.
1 0
0 0 1
After programming the backbone, program monitors and telephones following the
instructions shown on page 49 and 51.
Program all the other doorpanels in the same way.
Do NOT program more than one house doorpanel at the same time.
REMEMBER: It is necessary to program the backbone code only if the panel is part of a system
equipped with general doorpanel/s (see note).
BACKBONE CODE PROGRAMMING
The general doorpanel enters programming mode
13:15
Insert the code of the backbone to be programmed
(between 1 and 250), then 001code and press the
bell button. Both doorpanels will produce tones to
indicate that programming has been succesfully
O.K.
carried out.
In order to exit program mode, set microswitch number 5 of
C
ANCEL
the detached house doorpanel to OFF and press "C" button
of the general doorpanel.
after pressing the key button and inserting the
installer secret code (factory value 1315).