How To Operate - ARIETE 577 Mode D'emploi

APPLIANCE DESCRIPTION (Fig. 1)
A Filler cap
B Lid
D Graduated goblet
D Blades
E Motor body
F Operating dial
G Automatic operation button for mixing
H Automatic operation button for crushing ice
I Automatic pulse operation button
L Connecting joint
M Food presser

HOW TO OPERATE

This appliance is equipped with a dual safety device, on the motor body (E) and on the lid (B).
The motor body safety device allows to stop the operation when the goblet is raised (C). The safety
device on the lid stops or prevents operation when the lid is not properly positioned on the goblet.
The lid is equipped with a hook that engages in the handle and that, connected to the motor body,
prevents the operation without a specific contact.
- Make sure the appliance is unplugged and the operation dial (F) is on position "0".
- Position the goblet (C) on the motor body (E), always with the handle in the position shown in Fig.
2, matching the arrow on the goblet side with the one on the motor body.
- Cut fruit and vegetable into small pieces and place them into the goblet (C) adding water or milk
in an amount not exceeding the MAX 2.0 l level (the minimum filling is 400 ml).
- Position the lid (B) on the goblet (C) so that the lid hook engages with the goblet handle and press
it slightly downwards until it locks in place (Fig. 3).
- Close the upper hole of the lid (B) by inserting the apposite cap (A) and rotating it clockwise (Fig.
4). Make sure the lid (B) and the cap (A) are properly inserted to prevent food from coming out
during the processing stages.
- Plug power cord into a socket. The red light underneath the "Pulse" (I) button will start blinking and
will show that the appliance is ready for use.
- Start the appliance by turning the operating dial (F) clockwise up to the first or the second notch
(low speed) to start the blades. According to requirements, the speed can be increased by rotating
the dial (F) further.
If the appliance should fail to start, make sure the goblet and the lid are fitted properly. The appli-
ance is fitted with a dual safety device to prevent it from operating if the goblet is not fitted or if it
has been fitted incorrectly and prevents the blade from rotating if the lid is not suitably closed.
- To stop the operation, turn the operating dial (F) to «0».
- For using the automatic operation, turn the operating dial (F) clockwise to "M"; the 3 automatic
operation buttons (G-H-I-) will go on in blue. According to requirements, press the required button.
After 30 seconds downtime, the selection will be reset; the "Pulse" light (I) will flash again in red,
the other two will go off and it will be necessary to position the handle on the "0" position to select
the program.
- 9 -
EN