Your New Appliance; Accessories; Gas Burners; Switching On A Burner - NEFF T26R46 Serie Notice D'utilisation

Your new appliance

Page 2 shows an overall view of your new appliance as well as
the burner power.

Accessories

Depending on the model, the hob may include the following
accessories. These can also be acquired from the Technical
Assistance Service.

Gas burners

There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.
Additional wok pan support
Only for use on wok burners
with pans with a round base.
Using these pans may cause
some temporary deformation
of the grease drip tray. This is
normal and does not affect
the operation of the appli-
ance.
Additional coffee maker
support
Only for use on the auxiliary
burner with pans which are no
more than 12 cm in diameter.
--------
Code
Z2471X0 Additional wok pan support: cast iron (4-5 kW)
Z2472X0 Additional wok pan support: cast iron (3.3 kW)
Z2402X0 Additional coffee maker support
Z2480X0 Simmer Plate
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.

Switching on a burner

Press and turn the desired burner control knob anticlockwise to
the required position. The flame will ignite automatically and the
hotplate indicator light will come on after a few seconds.
If the burner does not switch on, wait at least a minute until
trying again.

Safety system

All the hotplates have a security device (thermocouple).
If the burner is switched off during operation (e.g. due to a
draught), the appliance automatically switches on the hotplate
again.
If reignition is not successful (e.g. due to food remains on the
burner), the supply of gas to this burner is cut off and the
burner hotplate indicator flashes. Turn the control knob to 0
and check the section on Operating indicators and error
messages.
Simmer Plate
This accessory has been
designed to reduce the level
of heat at the lowest power
setting.
Place the accessory directly
on the pan support with the
cones facing upwards, never
directly over the burner. Cen-
tre the pan over the acces-
sory.
13