Door Panel Installation - golmar Stadio Plus T4000ML Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DOOR PANEL INSTALLATION

Break the bottom flange
to pass the cables through.
H
old the door panel on the embedding box.
Select a direction to open the door panel; this selection should ease
the door panel wiring.
The opening direction will be settled through the hinges position,
that must be passed through the header clips as shown.
For example, if the hinges are placed on both clips of the lower
header, the door panel will open downwards; if they are placed
on the right clips of both headers, the door panel will open to left.
To hold the door panel on the embedding box,
insert the hinges in the embedding box lockers
as shown.
19
P
reparing the embedding box.
Pass the wiring through the hole made in
the bottom part of the embedding box.
Level and flush the embedding box.
Once the embedding box is placed,
remove the protective labels
from the attaching door panel holes.
20
DOOR PANEL INSTALLATION
P
lace the nameplate labels.
Open the label holder.
F
inal adjustments.
Once the nameplate labels are placed, wire the
lamps from different modules and connect them
to terminals L1 and L2 of the sound module,
as it's shown on the installation diagrams.
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown.
C
lose the door panel.
Fix the door panel by using the supplied
screws.
Finish the door panel assembly by pressing
the closing heads.
Place the label and
close.

Publicité

Table des Matières
loading

Table des Matières