Door Panel Installation - golmar Rock Série Manuel D'installation

DOOR PANEL INSTALLATION

E
mbedding box positioning.
1650
The upper part of the door panel should be placed at 1,65m. height roughly.
The hole dimensions are: 131(W) x 131(Al) x 45(D) mm.
The door panel has been designed to be placed under most of the environmental conditions.
However it's recommended to take additional cautions like rainproof covers. To obtain
a good quality picture on video door entry systems, avoid direct incidence from light sources.
Break the bottom flange to pass the cables through.
Pass the wiring through the hole made in
the bottom part of the embedding box.
Level and flush the embedding box.
Once the embedding box is placed,
remove the protective labels
from the attaching door panel holes.
27
1850
1450
P
reparing the embedding box.
28
DOOR PANEL INSTALLATION
F
inal adjustments.
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown.
The telecamera has a pan and tilt mechanism built in
to adjust the telecamera position.
C
lose the door panel.
Fix the door panel by using the supplied screws.