Chain; Adjusting The Chain Tension - Sherco 50 SE-SM Manuel Du Propriétaire

50 SE-SM
Checks and maintenance
n CHAIN
For the best life of the chain, it is recom-
mended that you periodically check the ten-
sion and always keep it clean and lubricated.
The lubricant must not under any circums-
tances get on the rear tire or the brake disc,
otherwise the grip of the tire on the ground
and the action of the rear brake would be
reduced, this is very important as control of
the bike could to be impaired.

ADJUSTING THE CHAIN TENSION

If the chain slack exceeds 20 mm you must
adjust it.
• Loosen the axle nut
• Loosen the lock nuts A on both
sides of the swingarm.
• Use the adjusting screws B on both sides
until reaching the desired tension.
• Tighten the lock nuts A on both sides of
the swingarm.
• Tighten the axle
1
specified torque.
86
.
1
according to the
1
A
B