Controls; Replacement; Checks And Maintenance; Legend Symbols - Sherco 50 SE-SM Manuel Du Propriétaire

Checks and maintenance

n LEGEND SYMBOLS
Tightening torque
L
1
2
3
WARNING
• Hot oil can cause severe burns!
• Dispose of the used oil in accordance with local regulations.
NOTE
Replace the transmission oil after the first 500 km. For the following oil changes, see the table at
using the lubricants recommended in
G
Medium strength thread lock
L
☛ p.62.
G
L
CHECKING THETRANSMISSION OIL
Keep the motorcycle upright in relationship to
the ground.
Remove the screw
2
lower edge of the opening.
To restore the level, proceed to fill by means
of filler cap .
1
Once finished, replace the cap
screw ).
2
REPLACING THE TRANSMISSION OIL
Always perform this operation when the
motor
Is hot:
- Position a container under the engine
- Remove the filler cap and the drain plug
- Completely drain the compartment
- Replace the plug
3
- Pour in 850 gr. / 820 cc of oil
- Check the level as described above
- Replace the filler cap
G
Grease
: the oil must reach the
and the
1
3
1
☛ p.92,
77