Checking The Front Brake Pads For Wear; Rear Brake; Checking The Rear Brake Fluid Level - Sherco 50 SE-SM Manuel Du Propriétaire

50 SE-SM
Checks and maintenance
CHECKING THE FRONT BRAKE
PADS FOR WEAR
The state of wear of the brake pads can be
checked by observing the end of the 2 pads
on the caliper (see arrow) they should have a
minimum thickness of 2 mm.
In the case of a lower thickness, immediately
replace them.
Note :
Perform this check according to the sche-
duleshown on the chart at
For replacement, contact a SHERCO autho-
rized service center.
n REAR BRAKE
CHECKING THE REAR BRAKE
FLUID LEVEL
Check for the presence of oil through the eye
glass .
1
The minimum oil level should never be below
the eye glass .
1
To restore the level proceed to fill by way of
the filler cap ( .
2
WARNING
If the lever becomes too soft there could be an air
bubble in the system, if this is the case,
immediately contact a SHERCO dealer.
NOTE
Use the oil indicated in
"Recommended Lubricants and Fluids" table.
80
p.92.
☛
☛
p.62 in the
2 1