Operating Instructions For The Speedometer - Sherco 50 SE-SM Manuel Du Propriétaire

n OPERATING INSTRUCTIONS FOR THE SPEEDOMETER
MODE
BUTTON
IGNITION
- Starting the bike: the meter performs
its ignition procedure (all the lights
light up briefly) and stay on.
- Wheel spin: the meter will turn on and
will remain on for 30 seconds if no
speed pulse is regenerated.
- Press a button: the meter will light up
and will stay on for 30 seconds if
no button is pressed.
SPEED
Speed and speed units (km / h
or mph) are permanently displayed.
The speed can vary from 0 to 199 in
both cases.
DISPLAY
Scroll between displays:
Press SET <2 seconds:
Displays the trip time or the km.
Press SET> 10 seconds:
change units km / h - mph.
Press MODE <2 seconds:
Displays the total, the trip A, the trip B.
Press MODE> 10 seconds:
allows you to enter the wheel mode.
Press MODE & SET> 2 seconds:
allows you to enter clock mode.
CLOCK
Format:
If units are in km → 24 h
If units are in mph → 12 o'clock
Press MODE <2 seconds:
increases the hour value.
Press MODE> 2 seconds: quickly increases
the time value.
Press SET <2 seconds:
increases the minute value.
Press SET> 2 seconds:
quickly increases the minute value.
Press MODE & SET> 2 seconds:
leaves The clock mode and saves the values.
NO ACTION> 10 seconds:
automatically exits clock mode without
saving.
TRIP A & TRIP B
Press MODE <2 seconds: choice of trip.
Press SET <2 seconds: Displays the time of
use or distance traveled.
Press SET> 2 seconds: reset.
WHEEL SIZE CONFIGURATION
Press MODE <2 seconds to change the size
of the wheel (50SM = 1850 / 50EN = 2070 /
XY-TY = 2190).
Press MODE & SET> 2 seconds:
leaves the wheel mode and saves the values.
NO ACTION> 10 seconds:
automatically exits without saving.
SET
BUTTON
69