Mixing Oil Tank; Starting The Engine; Stopping The Engine - Sherco 50 SE-SM Manuel Du Propriétaire

n MIXING OIL TANK
To refill, remove the tank cap (
Tank capacity is recorded at
After refilling, screw the cap back on.
Use the oil indicated on page 16 in the "Lubricants and Recommended Fluids" table.
n STARTING THE ENGINE
Rotate the fuel tap to either ON or RES (
Check that the gearbox is in neutral (
Pull in the clutch lever (
Take the bike off the side stand. To start the engine, rotate the Kickstarter lever outward and
give it a sharp blow down.
WARNING
Once the Kickstarter pedal is depressed, release it immediately. This avoids shocks to the whole starting
system and the operators foot.
COLD ENGINE STARTING:
Activate the choke by pushing it (
return the lever to the initial position.
n STOPPING THE ENGINE
To shut down the engine, perform the following operation:
- turn the key to the off position (see
N
NOTE
When the engine is off, always turn the fuel valve to the OFF position (
p.65).
☛
p.57.
☛
p.64).
☛
p.66).
☛
p.66).
☛
p.65), start the vehicle, wait a few seconds and then
☛
p.68).
☛
☛
p.64).
73