Prepare The Hood; Measure The Installation - Broan BW5030SSL Manuel D'instructions

INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. Long duct
runs, elbows
and transitions
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.

MEASURE THE INSTALLATION

6" ROUND DUCT
DECORATIVE FLUE
ROUND ELBOW
HOOD
9-3/4"
30" - 36" ABOVE
COOKING SURFACE
The minimum hood distance above cooktop MUST NOT BE
LESS than 30".
A maximum of 36" above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 36" are at the installer and users discretion;
providing that the ceiling height permits.
ROOF CAP
6"
ROUND DUCT
DECORATIVE
FLUE
HOOD
30" MIN. ABOVE
COOKING SURFACE
ROOF CAP
WALL CAP
HOOD
MOUNTING
BRACKET
10-5/8"
TO CENTER OF
BRACKET HOLES
3-3/8"
DUCT
CENTER
LINE

PREPARE THE HOOD

Unpack hood and check contents. You should receive:
1 - Hood
1 - Decorative Flue Assembly
1 - Damper / Duct Connector
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (installed in hood)
WALL
1 - Installation Manual
CAP
1 - Parts Bag containing:
10 - Mounting Screws (#8 x 3/8" Pan Head)
ROUND
ELBOW
7 - Mounting Screws (#8 x 1-1/2" Flat Head)
7 - Drywall Anchors
2 - Washers
DECORATIVE FLUE
DAMPER /
DUCT
CONNECTOR
MODELS BW5030SSL • BW5036SSL
7 MOUNTING
SCREWS
(no. 8 x 1½"
Flat Head)
UPPER
FLUE MOUNTING
BRACKET
LOWER
FLUE MOUNTING
BRACKET
Page 3
10 MOUNTING
SCREWS
(no. 8 x 3/8"
Pan Head)
2 WASHERS
HOOD
MOUNTING
BRACKET
7 DRYWALL
ANCHORS