Preparing To Use Your Phone; Preparing To Use The Handset; Inserting The Battery - Siemens Gigaset SL1 Mode D'emploi

Preparing to use your phone

Preparing to use your phone
The pack contains:
one SL 1 handset, one charger with power supply unit, one belt clip for the handset, one
battery, one set of operating instructions.

Preparing to use the handset

The display is protected by a plastic film. Remove the protective plastic film!

Inserting the battery

Insert the battery ensuring correct polarity – see figure on left.
◆
Position the battery cover so that it is open by around 3 mm, then slide up until it
◆
closes with a click,
To open the battery cover, press on the recessed area and slide down.
◆
Use only the rechargeable battery recommended by Siemens on page 26!
Never use a conventional battery (non-rechargeable) or other battery
W
type as this may cause significant damage to health and property. For
example, the jacket of the battery could be destroyed (hazardous). The
phone could also malfunction or be damaged.
Charging the battery
Place the handset in the charger with the display facing the front. Now leave the
handset in the charger for the battery to charge – the battery is supplied uncharged.
Battery charging is indicated in the top right of the display by the flashing battery
icon =.
For the initial charge we recommend a continuous, uninterrupted
charging period of five hours, whatever charge status is indicated. After
W
a while the charge capacity of the battery will decrease for technical
reasons.
6