Software Configuration (Gui) - Helios ecovent verso KWL 45 STS-UP Notice De Montage Et D'utilisation

Installation and operating instructions
UK
NOTE
NOTE
Control set KWL 45 STS-UP/HS
6.2 Software configuration
Ensure that the KWL 45 BEU controller is connected to the PC by USB connection cable (note section 6.1).
NOTE:
If there is no USB connection to the controller and/or if there is no control voltage at the controller, then only saved con-
figurations can be opened and edited. The uploading or reading out of configurations to or from the controller is not
possible in this case!
1. Basic functions
©
1. Read from controller
©
2. Write to controller Click button
3. Load factory settings from controller
NOTE: The factory settings are marked by the index *
4. Load from file © Click button
5. Save to file © Click button
˜
š
Click button
›
˜
© Click button
œ

š ›
15
œ 