Maintenance; Cleaning The Robot And Charging Dock; Main Brush, Side Brushes And Driving Wheels - ECOVACS DEEBOT D77 Manuel D'instructions

4. Maintenance

4.1 Cleaning the Robot and Charging Dock

Cleaning the Robot
Turn off the robot
Use a cleaning cloth dampened with water or neutral detergent, wipe and dry the product. Do not let water
penetrate inside the product.

4.2 Main Brush, Side Brushes and Driving Wheels

Cleaning the Main Brush
It's suggested to clean the Main Brush after every 4~5 cleaning cycles.
Clean and Replace Side Brushes
Tips:
1. The side brushes incur a lot of wear. We suggest you inspect them after each use and change if necessary.
2. When installing the side brush, make sure its color matches the slot color or the brush will not work normally.
Cleaning the Driving Wheels
EN
Unscrew the screw on the
Main Brush and remove
the frame of the Main
Brush.
Remove any hair and dust
around the belt.
To clean the side brushes,
pull them out and clean
with dry cloth.
Use the main brush cleaning tool to remove any dust or hair tangled in the driving
wheels.
Cleaning the Charging Dock
Remove the power plug from receptacle
Take out the Main Brush.
Remove the hair on the Main
Brush with the provided Main
Brush Cleaning Tool to cut
off the hair.
Re-install the Main Brush and
its frame. Tighten the screw.
To replace, insert each side
brush into the slot with the
matching color. Press until
you hear a click.