Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
power And Ground connections
IMPORTANT: Disconnect the vehicle's negative (–) battery terminal before beginning the installation.
The GX series amplifiers are capable of delivering high power levels, and require a heavy-duty and reliable connection to the vehicle's electrical
system to achieve optimal performance. Please adhere to the following instructions carefully.
usIng the connectors
GX-series amplifiers use the same type of screw terminals for power and speaker connections. This type of terminal is easy to use and allows the
easy connection of large-gauge wire.
To use the connectors, use a Phillips screwdriver to loosen the connector's set screw, insert the bare wire and tighten the set screw to secure the
wire in the connector, as shown in the illustration below.
Loosen Screw
IMPORTANT: Make sure the (+) and (–) speaker bare wires do not touch each other or the other terminal at both the amplifier terminals and speaker
terminals. Touching wires can cause a short circuit that can damage the amplifier.
4
Insert Wire
Tighten Screw
Under Washer
Publicité
Table des Matières
