Dometic 300 Série Mode D'emploi page 3

NFORMATION
R REQUIRED,
ODUCT.
E.
FORMATION.
5 p.m. ET)
AIRS (if necessary)
-sealed bowl-to-base
bly – Unlike other
c foot-pedal toilets, the
d base of 300, 310,
0 series toilets should
eparated for any
Each Dometic toilet is factory-tested to assure a
watertight seal in toilet bowl before it is shipped.
After installation at the RV or other vehicle factory, the
entire toilet system is tested for leaks. This process
requires holding the flush ball open with a device which
may temporarily distort the ball seal from its original
shape and, as a result, cause the seal to leak water into
the waste tank during normal use. The ball seal may need
to be reconditioned to its original shape.
IF NEW TOILET DOES NOT HOLD WATER IN BOWL...
Please follow the procedures below before attempting to
replace the seal.
1. Hold flush ball open by pressing on pedal.
2. Using finger, apply moderate downward pressure around
edge of ball seal.
3. Close flush ball.
4. Keeping flush ball closed, pour one quart of hot tap water
into toilet bowl.
5. Let water cool completely.
6. Check for leak.
If leak still persists, flush ball seal should be replaced.
Follow instructions provided with replacement seal kit.