Télécharger Imprimer la page

LiftMaster 975LM Manuel D'utilisation page 2

Publicité

Les langues disponibles

Les langues disponibles

NOTE: Periodic adjustment of the beam may be required from
time to time and is to be used only with the vehicle used during
the initial setup. Re-set the adjustment according to SETUP and
ADJUSTING steps 1-3 for that vehicle.
CAUTION
ATTENTION
LASER RADIATION
DO NOT STARE INTO BEAM
RAYONNEMENT LASER
NE PAS REGARDER DIRECTEMENT
LE RAYONNEMENT LASER
Maximum power output: < 1mW @ 635 - 670nm
Puissance de sortie maximum: < 1mW @ 635 - 670nm
CLASS II LASER PRODUCT
APPAREIL AU LASER DE CLASSE II
OPERATION
1. Open the garage door by activating the automatic garage door
opener and drive your vehicle into parking space.
2. The red beam can be seen moving across the hood of your
vehicle as you drive further into the garage (Figure 5).
3. Stop the vehicle when the beam is positioned at the location
you confirmed in step 3 during the Set Up and Adjustment
(Figure 6).
NOTE: The laser is automatically actuated every time you drive
into your garage. The beam will automatically deactivate after
approximately 1 minute. A residual reflection of the red beam
from the windshield may appear on the walls or objects in your
garage. When operating a vehicle, always ensure that there are no
objects on the floor of the garage or in the path of your vehicle.
This parking assist is not a substitute for safe parking practices.
TROUBLESHOOTING
If the laser does not emit a beam:
• Verify nothing is obstructing the safety sensor lens.
• Verify nothing is blocking the parking assist lens.
• Verify that connections are not reversed wired.
• Verify that all connections are secure as identified in
theinstallation.
• Confirm that the parking assist is aimed toward thegarage
floor.
• Obstruct the path of the safety reversing sensors andlook for
the red spot on the garage floor.
Please refer to your Liftmaster owner's manual for additional
information on your garage door opener and the safety sensors.
REPLACEMENT PARTS LIST
Wire Nuts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23B293
Parking Assist . . . . . . . . . . . . . . . . . . . . . . . . 975LM and 975LMC
To avoid eye INJURY or damage to product:
• NEVER point the laser at anyone.
• NEVER look directly into the laser beam.
• NEVER disassemble the laser.
• The parking assist is NOT a substitute for safe parking
practices.
• Use of controls or adjustments, or the performance or
procedures other than specified can result in hazardous
radiation exposure.
• ONLY for use on LiftMaster manufactured garage door
openers.
Figure 4
Figure 5
Figure 6
1-800-528-9131
LiftMaster.com
Parking Assist
Parking
Assist
Wire

Publicité

loading

Ce manuel est également adapté pour:

975lmc