LiftMaster HEAVY DUTY SHAFT COLLAR 98032 Mode D'emploi

APPLICATION
This replacement kit is only intended for the heavy duty style Residential
Jackshaft Operator with 4 holes on each end of the output shaft.
NOTE: The following images are for reference only. Your unit and shaft collar
may look different.
YOU MAY NEED:
• 3/8" 8-point socket or 3/8" Open End Wrench
• 9/16" socket or 9/16" Open End Wrench
• 6" Extender
PRE-INSTALLATION
1. Close the garage door.
2. Disconnect power from the outlet.
3. Remove the lower and upper front covers (A).
4. Disconnect and remove the batteries and set aside. (B).
5. Remove wires from the unit and label them for reinstallation. Disconnect
wires from the quick connect terminals (C).
6. Loosen the shaft collar. First, use a 9/16 socket or open end wrench to
loosen the 4 lock nuts completely off the lock washers. Then use a 3/8"
8-point socket or open end wrench to loosen the 4 set screws on the
collar (D).
7. Remove the two 14-10 x 2" screws holding the mounting bracket to the
wall (E).
8. Remove the motor unit from wall.
9. Discard the old shaft collar.
A
C
B
HEAVY DUTY SHAFT COLLAR 98032
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing ANY
service or maintenance
To prevent damage to the receiver logic board, DO NOT touch printed
circuit board of replacement receiver logic board during installation.
ALWAYS wear protective gloves and eye protection when changing the
battery or working around the battery compartment.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go
to www.P65Warnings.ca.gov.
Operator
Shaft
Collar
D
Set Screws
1
MODEL 041-0400-000
WARNING
CAUTION
E