Operation
Water drainage
-During dehumidifying modes, remove the upper drain
plug from the back of the unit, install the drain
connector(5/8" universal female mender) with 3/4"
hose(locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area
in your basement floor.
NOTE: During cooling mode, please reinstall the upper
drain plug to the unit securely to reach the maximum
performance and avoid leakage.
-If you can set the humidity level (portable with
humidity sensor), Please put the back duct for best
dehumidification effect, but the back duct doesn't need
to connect to window. If you can't set the humidity level
(portable without humidity sensor), please don't put the
back duct.
Remove the
upper drain plug
Continuous
drain hose
NOTE: Make sure the hose is secure so there are no
leaks.Direct the hose toward the drain, making sure that
there are no kinks that will stop the warter flowing.Place
the end of the hose into the drain and make sure the
end of the hose is down to let the water flow smoothly.
When the continuous drain hose is not used, ensure
that the drain plug and knob are installed firmly to
prevent leakage.
-When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times, the digital
display area shows "P1" . At this time the air
conditioning/dehumidification process will immediately stop.
However, the fan motor will continue to
operate(this is normal). Carefully move
the unit to a drain location, remove
the bottom drain plug and let the water
drain away. Reinstall the bottom drain
plug and restart the machine until
the "P1" symbol disappears. If the
error repeats, call for service.
NOTE: Be sure to reinstall the
bottom drain plug firmly to prevent
leakage before using the unit.
Press the power cord buckle
into the rear cover.
Maintenance
WARNING:
-Always unplug the unit before cleaning or servicing.
-DO NOT use flammable liquids or chemicals to clean the unit.
-DO NOT wash the unit under running water. Doing so
causes electrical danger.
-DO NOT operate the machine if the power supply was damaged
during cleaning. A damaged power cord must be replaced with a
new cord from the manufacturer.
Clean the Air Filter
Upper filter
(take out)
lower filter B
(take out)
Remove the air filter
CAUTION
DO NOT operate the unit without filter because dirt
and lint will clog it and reduce performance.
Maintenance Tips
-Be sure to clean the air filter every 2 weeks for optimal performance.
-The water collection tray should be drained immediately after P1
error occurs, and before storage to prevent mold.
-In households with animals, you will have to periodically wipe down
the grill to prevent blocked airflow due to animal hair.
Clean the Unit
Clean the unit using a damp, lint-free cloth and mild
detergent. Dry the unit with a dry, lint-free cloth.
Store the unit when not in use
-Drain the unit's water collection tray according to the instructions in
the following section.
-Run the appliance on FAN mode for 12 hours in a warm room to
dry it and prevent mold.
-Turn off the appliance and unplug it.
-Clean the air filter according to the instructions in the previous
section. Reinstall the clean, dry filter before storing.
-Remove the batteries from the remote control.
Be sure to store the unit in a cool, dark place. Exposure to direct
sunshine or extreme heat can shorten the lifespan of the unit.
15
EN
lower filter A
(Press the grill down
slightly and pull the lower
filter A out at the same time)