FS DUAL INTEL XEON RS7260 Guide De Démarrage Rapide page 29

No Power
• Check that the power LED on the motherboard is on.
• Make sure that the power connector is connected to the power supply.
• Check that the motherboard battery still supplies ~3VDC. If it does not, replace it.
• Check that the system input voltage is 100-120v or 180-240v.
• Turn the power switch on and off to test the system.
No Video
If the power is on but you have no video, remove all add-on cards and cables.
System Boot Failure
If the system does not display Power-On-Self-Test (POST) or does not respond after the power is
turned on, try the following:
• Turn on the system with only one DIMM module installed. If the system boots, check for bad DIMM
modules or slots by following the Memory Errors Troubleshooting procedure below.
Memory Errors
• Make sure that the DIMM modules are properly and fully installed.
• Confirm that you are using the correct memory. Also, it is recommended that you use the same
memory type and speed for all DIMMs in the system.
• Check for bad DIMM modules or slots by swapping modules between slots and noting the results.
Losing the System Setup Configuration
• Use a high quality power supply. A poor quality power supply may cause the system to lose the
CMOS setup information.
• Check that the motherboard battery still supplies ~3VDC. If it does not, replace it.
If the above steps do not fix the setup configuration problem, contact your vendor for repairs.
28