Radio (Optional); Start-Up; Adjusting The Volume - Jacuzzi j-sha mi Emploi Et Entretien

28
40°C
16:30
1
29
VOLUME
2
1
3
40°C
103
SEEK
MEM 1
MEM 2
MEM 3
VOLUME
16:30
2
2 3
40°C
103
SEEK
MEM 1
MEM 2
MEM 3
16:30
1
Radio
I Turn on the remote control by pressing the key
play will show the Jacuzzi logo and moving bubbles.
Turning on the radio
I (fig. 28) Then press the key
icon for the radio function, with the cursor flashing on the mes-
sage I/O.
I Make sure you are aiming the remote control at the receiver,
as shown in the figure, and press the key
on, and it will show the last frequency it was tuned to.
NOTE
• If tuning is not possible when the radio is turned on, the dis-
play will show the message "NO RX". Refer to the paragraph
on tuning.
3
• If the remote control is not used for about 1 minute, the display
panel light gradually fades until it goes out; press any button to
start it again.

Adjusting the volume

I Use the keys
crease the volume.
Frequency adjustment
I (fig. 29) The radio includes an automatic system for search-
ing for transmitting stations. To activate it, proceed as follows:
- Use the keys
SEEK.
- Aim the remote control at the receiver and do the following:
• press the
broadcasting on frequencies that are higher than the one
currently in use.
• press the
ately previous to the one currently in use.
Frequency memorization
I (fig. 30) It is possible to memorize 3 different frequencies
by doing the following:
44
(optional)
: The display will show an
or respectively to increase or de-
or to place the flashing cursor on
key to start searching for stations that are
key to go back to the frequency immedi-
: The dis-
. The radio will come