Craftsman Sears 139.18865 Manuel Du Propriétaire page 25

Please read and comply with the warnings and reinforcement instructions on page 24.
They apply to one-piece doors also.
Header Wall
• Center the bracket on the inside face of the door,
in line with the header bracket as shown. Mark
either the left and right, or the top and bottom
holes.
• Drill 5/16" pilot holes and fasten the door bracket
with hardware supplied.
All ONE-PIECE Door Installation Procedure
2x4 Support
Header
Bracket
Door
Bracket
Vertical
Centerline of
Garage Door
Finished Ceiling
25
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.).
Inside Edge
of Door or
Reinforcement Board
Door
Bracket
Hardware Shown Actual Size
Nut 5/16"-18
Lock Washer 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Écrou de
5/16 de po-18
Rondelle-frein
de 5/16 de po