Fixing - hager TG 500A Guide D'installation

Fixing

Fixing with flush-mounting box
For boxes of 60 mm diameter: use holes marked 60
For boxes of 85 mm diameter: use holes marked 85.
Fix the base using suitable screws.
Projecting mounting (Fig A)
- Place the base in the desired location, then mark the position of the 2 fixing holes
using a pencil (ref. mark 60 or 85).
- Drill holes using a 5 mm Ø drill bit.
- Fix the base using suitable fixings.
For interconnecting cabling,
remove the 2 fixing spacers and
insert them between the ceiling
and the mounting base by capping
the 2 selected fixing holes.
Optional locking of the detector
on the mounting base (Fig B).
Optional locking is designed to
prevent unauthorized removal of the
detector.
Using cutting pliers, cut the locking
nipple.
Opening will now be possible only
by means of a flat blade screwdriver.
Align the 2 locating arrows marked
on the mounting base and the
detectors, then lock the unit by
turning clockwise.
The detector cannot be locked on
its base if the battery is not
inserted in its housing.
Do not use force to lock the unit.
A
B
Fixing spacers
(11 mm)
29