Antenna Connections - Rockford Fosgate RAV Serie Manuel D'installation Et Fonctionnement

10. Connect the YELLOW (Back Up) wire to a source of constant +12V (for retaining memory on
user-programmed functions).The source should always have +12V, even when the ignition is off and
the car is not running.
11. Connect the RED (ACC +B) wire (Ignition) to a source of switched +12V (is on only when ignition
key is in "accessory" or "run" position).The switched signal is usually taken from the ACC (accessory)
position of the ignition. If the vehicle does not have an ACC position, connect the wire to the
switched ON position of the ignition.
12. Connect the BLUE (Remote B+) wire to the "Remote Turn-On" leads of the amplifier(s).This will
turn-on the external amplifiers when the source unit is powered on.
13. Connect the BLUE/RED (Auto Ant) wire to the "Power Antenna" lead.This will raise a fully
automatic antenna when the source unit is powered on and the unit is in Tuner Mode.
14. Connect the ORANGE/BLACK (Rear Camera) wire to a switch that provides +12V when the
vehicle is in placed in reverse.This will switch the source unit to AUX IN V1 video input for when a
rear camera is connected.
15a. Connecting Speakers (Not using RCA connection)
Connect the speaker wires to the corresponding speaker leads by soldering and heat shrinking all
connections for a reliable installation. DO NOT chassis ground any speaker leads as damage to the system
may result.
RCA Connections
15b.Connecting Speakers (Using RCA connection)
Connect RCA cables from the tuner unit into the corresponding inputs of the amplifier(s). Be sure to
route the signal cables away from any high current wires to prevent coupling noise from radiated
electrical fields into the audio signal.The AUX OUT FL white and FR red RCAs connect to the
Front speaker's amplifier.The AUX OUT RL white and RR red RCAs connect to the Rear
speaker's amplifier.The SUB WOOFER RCA connects to the Subwoofer amplifier.The CENTER
RCA connects to the Center speaker's amplifier
16. Connect the AUX IN L1, R1, L2 and R2 to the external audio source (this inserts the audio before
the volume control on the source unit).The input voltage this circuit can accept is 1–3V RMS.
17. Connect the AUX IN V1 to a external rear camera if the wire in step 14 is being connected for that
use.The AUX IN V1 and V2 can be connected to an external video source.The source unit can switch
between DVD viewing and the external video connections.
18. The AUX OUT V1 and V2 RCAs can be connected to additional video screens.
Optical Cable
19. Connect one end of the supplied optical cable into the SPDIF IN port on the tuner unit. Required for
DVD audio.
13-Pin DIN Communication Cable
20. Connect one end of the 13-pin DIN communication cable into the HEAD port on the tuner unit.

Antenna Connections

21. Connect the TV Antennas by plugging the antenna cables into the TV ANT connectors. Be sure the
antennas are securely grounded to the vehicle for proper reception.
22. Connect the Radio Antenna by plugging the antenna cable into the RADIO ANT connector. Be sure
the antenna is securely grounded to the vehicle for proper radio reception.
I
NSTALLATION
9