Precaution - Rockford Fosgate RAV Serie Manuel D'installation Et Fonctionnement

P
RECAUTIONS
SOURCE UNIT
Operating Temperature
Be sure the temperature inside the vehicle is between –10° C and +65° C (+14°F and +149°F).
DO NOT play a disc if the temperature is higher or lower than the operating range.
Moisture Condensation
The CD or DVD playback may waver due to condensation. If this occurs, remove the disc from
the source unit and wait approximately an hour for the moisture to evaporate.
Environment Exposure
DO NOT expose the Source Unit to any of the following: direct sun and heat, high humidity,
excessive dust, excessive vibration and rain or water.
Handling the Detachable Faceplate
DO NOT drop or cause shock to the faceplate as serious damage may occur. Protect the
faceplate by storing it in the supplied carrying case.
Avoid Mechanical Malfunction
DO NOT grab a disc while it is being automatically loaded into the source unit. Doing this may
cause serious damage to the playback mechanism and/or damage to the disc.
IR REMOTE CONTROLLER
Environment Exposure
DO NOT expose the IR Remote to any of the following: direct sun and heat, high humidity and
rain or water.
Handling the IR Remote
DO NOT drop or cause shock to the IR Remote as serious damage may occur.
COMPACT DISCS–CDs and DVDs
Disc Handling and Care
DO NOT touch the playing side (opposite of label side) of the disc.When handling the disc, only
the outer edges or center hole of the disc should be touched. DO NOT affix any sticker or label
to the disc. DO NOT apply vinyl record spray, anti-static agent, acetone, or any other volatile
chemicals to the disc.
Damaged Disc
DO NOT play a cracked, warped, or damaged disc. Doing this may cause serious damage to the
playback mechanism.
New Discs
The CD/DVD player will eject discs that have either been inserted incorrectly or have irregular
surfaces. If a new disc is ejected after loading, feel around the outer edge of the disc and its center
hole. Any small burrs or irregularities could inhibit proper loading of the disc.To remove the burrs,
rub the inside edge of the hole and outside edge of the disc with an object such as a ball point
pen.
4