Operation-Basic; Initial Setup; Reset Button; Power On/Off - Rockford Fosgate RAV Serie Manuel D'installation Et Fonctionnement

O – B
PERATION ASIC

INITIAL SETUP

NOTE: Items shown in () refer to remote control functions.

RESET BUTTON

CAUTION: Do not press the Reset Button too hard
or you may cause damage that may void
your warranty. If you need assistance,
please consult an Authorized Rockford
Fosgate Dealer.
1. Insert a paper clip or other slender object into the Reset
Button hole in the lower right corner of the unit and gently
press it in until the button clicks.

POWER ON/OFF

1. Press the VOLUME (PWR) button to turn the unit on.
2. Press and hold the VOLUME button again to turn the unit off.
Just pressing the PWR button on the remote will turn the unit
off.
Any Button Wake-Up
Press any button on the unit, except the (eject) button to "wake-up"
the radio from sleep mode. Only pressing the PWR button or ENT
(joystick) on the remote will "wake up" the unit.

VIDEO SCREEN

CAUTION:To prevent accidents, never use the video
screen to view DVDs or make menu
selections while driving the vehicle.
When the unit is first turned on, the video screen will activate and move into a viewing position. Once the
screen position has been set, other than angle, the screen will always open to that position.
NOTE: If the screen has been angled for viewing, always ensure the screen is repositioned straight to the
unit before attempting to close the screen, to turn off the unit or to turn off the vehicle.
Open
Pressing the open button will turn on the unit and position the
screen to the set viewing position. Pressing the Open button while
the screen is open will close the screen completely and the LCD
display will show the current mode information. If the screen was
closed when the unit or vehicle was turned off, the screen will
remain closed when the unit is turned back on, unless the Open
button is pressed.
While in the open position, press and hold the Open button to lay
the video screen flat down without fully retracting.This is useful
when you need to access heater controls and such that the screen
may block when open. Press the Open button to reopen the screen.
NOTE:This function only works on the Source Unit.
I/O (In / Out)
While the screen is in the open position, press the I/O button to
slide the screen slightly inward or outward. Once set, the unit will
remember the position whenever the screen is opened.
14
Reset
Remote
Remote