Standard Mount; Iso-Din Mount - Rockford Fosgate RAV Serie Manuel D'installation Et Fonctionnement

STANDARD MOUNT

Installing;
• Mount the Locks for the Installation
Sleeve onto the source unit (use
supplied screws).
• Mount the Installation Sleeve into a
secure instrument panel.
NOTE: Make sure to mount the Source
Unit as close to horizontal as
possible for optimum CD/DVD
Player performance. Mounting
Angles of up to ±20˚ from
horizontal can be
accommodated.
NOTE: Make sure there is adequate
room for the motorized screen
to move into a viewing position.
• Bend Appropriate Tabs on all sides of
the installation sleeve.
• Install Source Unit by sliding unit into
installation sleeve until it clicks into
place.
• Mount Back Strap securely behind the
instrument panel to prevent source unit
vibration.
• Back strap Screw should be 6mm max (use
supplied screw).
Removal;
• Disconnect Back Strap from rear of radio (if
used).
• Remove Trim Piece from front of radio.
• Insert Release Keys into left and right sides of source unit to
disengage locks.
• Remove Source Unit from installation sleeve with release
keys.

ISO-DIN MOUNT

Installing;
• Remove Trim Piece and Installation Sleeve from source unit.
• Factory Bracket should align with two mounting holes on each side of source unit.
• ISO Screws should be 6mm max (use supplied screws).
• Install Source Unit into instrument panel.
Sleeve
Back Strap
Dash
Screw
I
NSTALLATION
Dash
Release Key
Factory Bracket
Trim
Dash
Trim
7