Manual Mode Operation - Weston PRO-3000 Mode D'emploi

MANUAL MODE OPERATION

BEFORE ATTEMPTING VACUUM
PACKAGING, BE SURE THAT THE
VACUUM SEALER IS SET UP IN
ACCORDANCE WITH ALL OF THE
SAFETY PRECAUTIONS LISTED IN
THIS BOOKLET.
1. With the Vacuum Sealer plugged
in and the power turned on, check
to be sure the Manual Mode Light
is illuminated; if not press the Mode
Button until the manual light is on
(FIGURE 6).
2. Place the items to be vacuum
sealed into a vacuum bag. Allow at
least 2" (5 cm) at the open end of
the bag in order to create enough
seal space. Be sure not to cover the
Vacuum Ports (FIGURE 7).
3. Close the Clear Acrylic Vacuum Lid
and check that the bag opening is in
the center of the Vacuum Chamber
(FIGURE 7).
4. While monitoring the vacuum
bag, press and release START
Button. The 2-Piston Vacuum Pump
will begin removing air from the bag.
When the desired level of air has been evacuated from the bag, press and
release the Manual Bag Seal Button. It will start the sealing bag process.
Note: You may need to apply light pressure to the Clear Acrylic Vacuum Lid
during this process.
Note: It requires some vacuum pressure in the bag to get good seal for the
bag.
5. Once the LED Seal Window has reached "0", the Vacuum Sealer will au-
tomatically stop the 2-Piston Vacuum Pump and release the vacuum pressure
moments later. DO NOT ATTEMPT TO PULL THE CLEAR ACRYLIC VAC-
UUM LID OPEN BEFORE THE VACUUM HAS BEEN RELEASED, SEVERE
DAMAGE TO THE SEALING BAR WILL RESULT.
NOTE: The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS. For
best results, only use the recommended vacuum bags with an embossed or mesh lining.
DO NOT USE HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other
than the uses described in this booklet, could potentially damage the appliance and void
the warranty!
12
Mode
Manual
Button
Mode Light
Leave 2"
Seal
Space
FIGURE 6
Manual Bag
Seal Button
FIGURE 7
Vacuum
Ports
Bag in Center of
Vacuum Chamber