Control Buttons - Weston PRO-3000 Mode D'emploi

CONTROL BUTTONS

. Power Button: After plugging the Vacuum Sealer into the power supply
and the appliance, press the Power Button in the lower left corner of the
Control Panel. The Power Light and all of the LED Lights on the Control
Panel will now be activated. If you wish to stop the vacuum process, in either
Manual or Automatic Mode, before the bag is sealed, press the Power Button
one time. This will stop the 2-Piston Vacuum Pump and after a moment will
release the vacuum pressure holding the Acrylic Lid down.
. Mode Button: By pressing the Mode Button, you can switch between the
Automatic and Manual Modes.
. The Auto Light will be illuminated when the unit is in the AUTOMATIC
MODE. The Vacuum Sealer will begin sealing the bag after the air in
the bag has been evacuated.
. The Manual Light will be illuminated when the unit is in the MANUAL
MODE; you can now seal the bag at anytime during the vacuum
process. This is useful when sealing delicate items that might be
crushed if the Vacuum Sealer is allowed to reach its maximum vacuum
level. More information about the manual mode can be found in the
"Manual Mode" section of this booklet.
. Seal Time Adjustment + and - : The Seal Time Buttons adjusts the number
of seconds that the Sealing Bar will apply heat to create the bag's seal. The
optimal time for different brands of bags can be adjusted using the Plus (+) or
Minus (-) Buttons. See the "Bag Sealing" section in this booklet for further
information on sealing vacuum bags.
. Seal Time Window: The numeric LED Seal Window indicates the number
of seconds that the Sealing Bar will be activated to apply heat to the bag that
creates the seal. Once the Seal Bar is activated, the display will countdown
to "0". See the "Bag Sealing" section in this booklet for further information on
sealing vacuum bags.
. Vacuum Process Window: The numeric LED Vacuum Window indicates
the level of vacuum that the Vacuum Sealer has attained. The display will
count up from "0" to "9". Please see the "Vacuum Operation" section in this
booklet for further information.
. Start Button: The Start Button starts the 2-Piston Vacuum Pump, which
engages the air evacuation process.
. Manual Bag Seal Button: This button will start the seal process at any time
whether in Automatic or Manual Modes. More information about the Manual
Mode can be found in the "Manual Mode" section of his booklet.
FIGURE 3
9