Transmitter Controls - ECX TORMENT ECX4000 Manuel D'utilisation

TRANSMITTER CONTROLS

reverse sWItch
BIND ST TH
N R N R
Allows you to change the direction
of steering (ST. REV) and throttle (TH.
REV) controls. (Default settings are
"N" for steering and "R" for throttle)
steerIng trIM
Adjust to make the vehicle
drive straight with no input
at the steering wheel
throttle trIM
Adjusts the neutral point of
the electronic speed control
PoWer sWItch
Power on
ST. TRIM
or off the
transmitter
TH. TRIM
Battery level IndIcator
Solid Green: Battery voltage
is good (Above 4V).
Flashing Green: Battery
voltage is critically low
(below 4V). Replace batteries.
rF Mode
The DX2E has a France RF Mode that complies
with French regulations. The DX2E must be in
France mode when used outdoors in France.
At all other times, the transmitter should be
in Standard mode.
BIND ST TH
N R N R
ST. TRIM
TH. TRIM
ST. RATE
France mode
Turn the wheel full left, pull the trigger full throttle,
and hold down the bind button while turning on
the transmitter. The Green LED will flash twice.
steerIng rate
Adjusts the amount the front
wheels move when the steering
wheel is turned left or right
steerIng Wheel
ST. RATE
Control steering. Right and Left
steering with ST. REV Switch
on N (See ST. REV switch)
ST. TRIM
throttle trIgger
TH. TRIM
Forward Stop
(when TH.
REV switch on R)
Controls power to motor for forward
or reverse (See TH. REV switch)
Standard mode
(deFault preSet Set at Factory)
Turn the wheel full right, pull the trigger full
throttle, and hold down the bind button while
turning on the transmitter. The Green LED
will flash once.
EN
ST. RATE
Reverse
(when TH.
REV switch on R)
5