Care And Cleaning - Zanussi ZFV819K Notice D'utilisation

It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
The control Panel is a sensor field.
Touch the symbols for 1 second to
activate the functions.
To operate the hood:
1. Turn on the appliance by pressing the
symbol.
You can now activate the functions.
2. To activate the function touch the symbol.
3. If needed, touch the light symbol
illuminate the cooking surface.
To turn off the appliance press the
again.
ACTIVATING MAXIMUM MOTOR SPEED
When you touch , the Maximum Motor Speed
starts to operate for 8 minutes. After that time, the
appliance returns to its previous speed settings.
When the function is turned on,
additional touch on
any effects.

CARE AND CLEANING

NOTES ON CLEANING
Cleaning
Agents
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones
or burners, gentle frying.
While boiling and frying big quantities of food without a lid,
cooking on multiple cooking zones or burners.
While boiling and frying big quantities of food without a lid,
big humidity.
to
symbol
does not have
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild
detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance
must be cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
FILTER NOTIFICATION
Filter alarm reminds to change or clean the charcoal
filter and clean the grease filter. The filter indicator
is turned on for 30 seconds if the grease filter
must be cleaned. The filter indicator
30 seconds if the charcoal filter must be replaced
or cleaned.
Refer to cleaning the grease filter in
care and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To activate or deactivate function:
1. Switch on the control panel.
2. Make sure that the icons are turned off.
3. To activate function touch
If the function is activated, the filter icon
five times.
4. To deactivate function touch
If the function is deactivated, the filter icon
flashes three times.
To reset the function touch
flashes for
for 3 seconds.
flashes
for 3 seconds.
for 3 seconds.
27