Care And Cleaning; Cleaning The Grease Filter; Replacing The Charcoal Filter; Replacing The Lamp - Zanussi ZFI719A Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
It is recommended to leave the hood
operating for approximately 15
minutes after cooking.
To operate the hood:
1. Press the first speed button
the appliance.

CARE AND CLEANING

CLEANING THE GREASE FILTER

Each filter must be cleaned at least once a month.
Filters are mounted with the use of clips and pins
on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip on the
filter panel underneath the hood (1).
1
2
2. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first two
steps in reverse order.
Repeat the steps for all filters if applicable.
While boiling, frying big quantities of food without a lid, cooking on multiple
cooking zones or burners.
While boiling, frying big quantities of food without a lid, big humidity. The
hood operates on maximum speed. After 8 minutes the appliance returns to
previous setting.
to switch on
2. If needed, press the light button
illuminate the cooking surface.
3. If needed, change the speed by pressing the
desired button.
To turn off the appliance press the first speed
button again.

REPLACING THE CHARCOAL FILTER

WARNING! The charcoal filter is non-
washable!
The time of saturation of the charcoal filter varies
depending on the type of cooking and the regularity
of cleaning the grease filter.
To replace the filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. press the tab (1) and slightly tilt the front of the
filter.
1 1
3. To install a new filter, perform the same steps
in reverse order.
In any case, it is necessary to replace the filters at
least every four months.

REPLACING THE LAMP

This appliance is supplied with a LED lamp. This
part can be replaced by a technician only. In case
of any malfunction refer to "Service" in the "Safety
Instructions" chapter.
to
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zfix19a

Table des Matières