Morphy Richards 43901 Mode D'emploi page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
43901MEE-Rev1:9225 47507 MEE pump - Jon
Treating scalds
Run cold water over the affected area immediately. Do not
stop to remove clothing, get medical help quickly.
OTHER SAFETY CONSIDERATIONS
Do not leave appliance unattended whilst in use.
Do not operate any appliance with a damaged cord or plug
or after the appliance malfunctions or has been damaged in
any manner. Contact Morphy Richards for advice.
The use of attachments or tools not recommended or sold
by Morphy Richards, may cause fire, electric shock or
injury.
Do not attempt to connect any other appliance to the base
unit or this appliance to another base unit.
Do not tamper with the connector in any way.
Do not use the appliance for any use other than to boil
water.
Do not place the appliance on or near a hot gas or electric
burner or in a heated oven.
The appliance must not be on the base unit when being
filled with water.
Morphy Richards recommends that the mains lead of the
cordless base cannot be repaired. If the mains lead is
damaged, the cordless base should be discarded and
replaced, contact Morphy Richards for advice.
Unplug from the outlet when not in use.
Do not move while the kettle is switched on.
To prevent damage to the appliance do not use alkaline
cleaning agents when cleaning, use a soft cloth and a mild
detergent.
Electrical requirements
Check that the voltage on the rating plate of your appliance
corresponds with your house electricity supply which must
be A.C. (Alternating Current).
WARNING: This appliance must be earthed.
UK only
If the socket outlets in your home are not suitable for the
plug supplied with this appliance, the plug should be
removed and the appropriate one fitted.
WARNING: The plug removed from the mains lead, if
severed, must be destroyed, as a plug with a bared
flexible cord is hazardous if engaged into a live socket
outlet.
Where used, should the fuse in the 13 amp plug require
changing, a 13 amp BS1362 fuse must be fitted.
4
29/7/09
16:40
Page 4
Features
⁄ Lid
¤ Push button lid release
‹ Spout filter
› Water level indicator
fi 360° connector (concealed)
fl Concealed element
‡ On/off switch with illumination
· Cordless base unit
Before first use
Before using the appliance for the first time, fill with water,
boil and pour away.
Operating the appliance
Wherever possible fill through the spout, as this helps to free
1
the filter from limescale build-up.
The integrated water level indicators allow you to easily see
the amount of water in the kettle.
Always ensure that the appliance is filled until the water is
visible through the level indicator.
Boil only as much water as you need as this saves electricity.
Place the appliance on the base unit, ensuring the appliance
2
locates on to the 360° connector.
The 360° connector allows the appliance to be located at any
position - ideal for left and right handed users and
convenient positioning on worktop.
3
Plug in and switch on at the wall socket if applicable.
Switch the appliance on. The on/off switch will light up.
4
5
When the water boils the appliance will switch off automatically.
Depending on the model varient you have purchased, the kettle
light will turn off.
If you are using the appliance for the first time, pour away the
boiled water and refill.
6
Lift the appliance from the base unit by the handle ensuring you
hold the appliance level.
To re-boil, switch to ON again. If the appliance has just
switched off wait a minute or so before switching it back on
again.
If you do not put in enough water, or switch on the appliance
when it is empty, the safety cut-out will switch off the power
automatically. If this happens, refill and wait a few minutes for
the element to cool, then use as normal.
Filter removal
1
Open the lid.
Lift the filter upwards from its location using the tab provided.
2
3
To refit the filter, slot it into the side wall guides and press down
firmly. Ensure the filter is correctly located into the central
guide.
WARNING: Make sure that the filter is put in correctly
otherwise the lid will not close.

Publicité

Table des Matières
loading

Table des Matières