Setup Menu - Briteq POWERPIXEL4-RGB Mode D'emploi

ENGLISH
 Always use a certified safety cable that can hold 12times the weight of the device
when installing the unit. This secondary safety attachment should be installed in a way
that no part of the installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not
be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical
installations are approved by an expert before using them for the first time. The installations should be
inspected every year by a skilled person to be sure that safety is still optimal.

SETUP MENU

With the setup menu you can fully configure the projector. All settings are preserved when the unit is
disconnected from the mains.
Browsing the setup menu:
General instructions for setup.
 Press the MODE button or UP/DOWN buttons to browse the different functions of the setup menu until the
required function is shown on the display.
 Press the ENTER button to access the function and change its parameters.
 The cursor of the value to change starts blinking. Use DOWN and UP button to change the value.
 Press the ENTER button again confirm and select the next parameter to adjust.
DMX ADDR
Used to set the desired DMX-address.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired DMX512 address. The last occupied DMX-address is
also shown: makes it easier to set the address of the next unit in the chain.
 Once the correct address shows on the display, press the ENTER button to save it.
Note: on RDM-compatible controllers this option can also be remotely set.
CH. MODE
Used to set the desired channel mode.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 POWERPIXEL4-RGB modes:
 03CH: all 4 projectors together RGB
 04CH: all 4 projectors together RGB + master dim/audio/strobe channel
 05CH: all 4 projectors together RGB + master dim + audio/strobe channel
 06CH: 2 groups of 2 projectors RGB + RGB
 12CH: all projectors individually RGB
 15CH: all projectors individually RGB + 3 channels for special functions.
 16CH: all projectors individually RGB + master dim
 POWERPIXEL8-RGB modes:
 03CH: all 4 projectors together RGB
 04CH: all 4 projectors together RGB + master dim/audio/strobe channel
 05CH: all 4 projectors together RGB + master dim + audio/strobe channel
 06CH: 2 groups of 4 projectors RGB + RGB
 12CH: 4 groups of 2 projectors RGB + RGB + RGB + RGB
 24CH: all projectors individually RGB
 27CH: all projectors individually RGB + 3 channels for special functions.
 32CH: all projectors individually RGB + master dim

Once the correct option shows on the display, press the ENTER button to save it.
Remark: on RDM-compatible controllers this option can also be remotely set.
BRITEQ
®
4/79
OPERATION MANUAL
POWERPIXEL4+8-RGB