Cleaning Grease Filters; Installing Grease Filters; Cooktop/Night Light Replacement; Oven Light Replacement - Panasonic NN-SD277 Manuel D'utilisation

Four à micro-ondes à hotte intégrée
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IP1012_38Q10CP_03_070328
2007.3.28
Care and Cleaning of Your Microwave Oven

Cleaning Grease Filters

The Grease Filters should be removed and cleaned often, at
least once a month.
1. Grasp the "metal ring" on the Grease Filter. Slide the
Grease Filter to the rear of oven.
2. Pull the Grease Filter out.
3. Use care when cleaning the Grease Filters. Corrosive clean-
ing agents, such as lye-based oven cleaners, may damage
the Grease Filters. Clean the Grease Filters with a warm
detergent solution. Do not use ammonia or other alkali
because it will darken metal. Light brushing can be used to
remove embedded dirt. Shake and remove moisture before
replacing.

Installing Grease Filters

1. Slide in the edge of the Grease Filters along the opening's
guide edges.
2. Push up front edge and pull forward until it fits.
guide
Caution: After removing the Grease Filter, be careful with the
sharp edges at the openings.
Never operate the Vent Fan without the Grease Filters in
place.

Cooktop/Night Light Replacement

Be careful as the Cooktop Light Cover and the bulb may be
hot.
1. Unplug microwave oven or disconnect power.
2. Loosen the screw to open the Cooktop Light Cover.
(Be careful not to lose the screw.)
3. Replace the old bulb with a new one.
Cooktop Light Cover
(use 115-125 V, 30 W bulb)
If this bulb is not available locally, contact your local
Panasonic dealer. Part number is F612E5H01AP.
4. Reinstall the Cooktop Light Cover with a screw.
17:09
Page 29
Grasp the ring
opening
Grease Filter
screw

Oven Light Replacement

Be careful as the Oven Light Cover and the bulb may be
hot.
1. Unplug microwave oven or disconnect power.
2. Remove the Vent Grille and Charcoal Filter.
(see page 26 for Charcoal Filter replacement).
3. Lift the tab of Oven Light Cover, and push back. Lift up and
remove the cover.
4. Replace the old bulb with a new one.
(use 115-125 V, 30 W bulb)
If this bulb is not available locally, contact your local
Panasonic dealer. Part number is F612E5H01AP.
5. Reinstall the Oven Light cover securely aligning the hole in
cover, onto the detent.
Oven Light Cover
detent
When cleaning the Oven Light Cover or the adjacent area,
clean with a soft damp cloth.
To avoid scratches, do not use harsh detergents or abrasives.
27
(continued)
hole

Publicité

Chapitres

Table des Matières
loading

Table des Matières