Cleaning Vent Grill (Oven Air Vent); Charcoal Filter Attachment/Replacement; Cleaning Grease Filters; Install Grease Filters - Panasonic NN-S262 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CARE OF YOUR MICROWAVE OVEN
Cleaning Vent Grille (Oven Air Vent)
Vent Grille can be removed and cleaned.
1. Open the oven door.
2. 1Pull the bottom of Vent Grille and 2 raise the Vent
Grille, 3 then pull out.
3. Soak Vent Grille in hot water with mild detergent. Wipe
with a soft cloth after rinsing well. Do not use ammonia
or a dishwasher.
Installing Vent Grille
1. Open the door.
2. Insert two tabs C of Vent Grille into slots A at the top
of the oven.
3. Push Vent Grille down to attach the metal to magnet,
then push ahead to insert hook A into the slit of hook B.
Be sure that tabs C C at the top and hooks B B
at the bottom of Vent Grille are positioned
correctly to prevent Vent Grille from falling off.
Vent Grille
Hook B
Magnet
Hook A
Metal
Charcoal Filter Attachment/Replacement (Optional)
If your oven is vented inside the kitchen, the optional
charcoal filter should be attached and replaced every 6
to 12 months, or more often if necessary. The charcoal
filter cannot be cleaned. To order a charcoal filter,
contact your local Panasonic dealer.
1. Remove the Vent Grille. (See "Cleaning Vent Grille".)
2. Install Charcoal Filter and adjust two holes. Secure
with 2 screws provided.
Charcoal Filter (NN-CF208P)
hole
3. Reinstall the Vent Grille. (See "Installing Vent Grille".)

Cleaning Grease Filters

The Grease Filters should be removed and cleaned
often, at least once a month.
1. Grasp the "metal ring" on the Grease Filter. Slide the
Grease Filter to the rear of oven.
2. Pull the Grease Filter out.
3. Use care when cleaning the Grease Filters. Corrosive
cleaning agents, such as lye-based oven cleaners,
may damage the Grease Filters. Clean the Grease
Filters with a warm detergent solution.
Do not use ammonia or other alkali because it will
darken metal. Light brushing can be used to remove
embedded dirt. Shake and remove moisture before
replacing.
Installing Grease Filters
1. Slide in the edge of the Grease Filters along the
opening's guide edges.
guide
2. Push up front edge and pull forward until it fits.
Caution: After removing the Grease Filter, be careful
with the sharp edges at the openings.
Never operate the Vent Fan without the Grease Filters
in place.
- 27 -
Grasp the ring
opening
Grease Filter

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nn-s252

Table des Matières