Bond HYFP50095-130 Guide D'utilisation page 6

ASSEMBLY INSTRUCTIONS
* Please keep owner's manual for future reference.
*If you have opened the carton and removed all packages, please disregard STEP 1 and 2. See STEP
3 directly.
STEP 1. (1) Open the carton and turn it upside down, make sure the 4
pieces of the carton open up as below Figure 1.
(2) Lift off the carton carefully and be wary of the accessories inside
falling away. Take away the box containing lava rocks.
(3) Take all the packing materials away except for the polyfoam rounding
the top of the fire table. See Figure 1.
STEP 3.
(I) Check each part before using the product. Make sure the
gas supply system is turned "OFF" before assembling.
See Figure A.
(II)Open the storing door on the fire table for the gas
tank. See Figure A.
(III) Put the gas tank in the metal stand. Make sure the gas
tank sits on the metal stand completely. Turn the wing screw on
the outer part of metal stand clockwise to secure the gas tank
tightly. See Figure D.
(IV) Locate the battery, remove the plastic cover first. Unscrew
the rubber cap of the Electric Ignitor, place a AAA battery into
the battery case. Make sure the positive pole ("+") faces
towards the cap. Screw the cap back to the battery case tightly.
See Figure B.
(V) Place the lava rocks evenly in the fire table pan on the top of
the fire fire table. See Figure C. DO NOT COVER THE IGNITION
SCREEN when placing the lava rocks into the fire table pan.
Always keep Ignition Screen visible.
** Connect the Pressure-Regulating Valve to the gas tank.
See Figure E .
1) Turn the cylinder valve clockwise to close the gas supply
on the gas tank.
2) Screw regulator coupling clockwise by hand only. Make
sure it is fastened.
STEP 2. (1) Turn the fire table heads up on a flat
ground.
(2) Cut off the binding tape on the polyfoam and
remove all the polyfoam rounding the top of the fire
table.
(3) Cut off the tie fastened to the regulator at the metal
stand and set it free for installation to Propane Tank.
See Figure 2.
E
6