Use Of The Unit - Alcad CCA-200 Mode D'emploi

1247004‐GB_v1.1
MESSAGES
Display Type de message
OcuP Displayed when attempting to register a code in a position which is already taken
Skips to the first free position emitting a beep.
rEP Displayed when attempting to register a code which is already programmed in another position.
Skips to the position where the programmed code is located, emitting a beep,
and allows the device to be reprogrammed.
no Displayed when pressing a device which is not programmed in the unit.
datE Displayed when a proximity element is used outside its period of validity.
ERRORS
Display Type of error
Err.M Memory error: memory card not inserted or faulty.
Err.M Memory error: memory card with incorrect format (from other equipment). Emits a beep.
Err.E Events error: wrong events card.
Err.E Events error: events card with incorrect format (from other equipment). Emits a beep.
Err Wrong password
USE OF THE UNIT
These units are designed for the remote control of garage doors, to send the activation commands
to control panels in which the card is inserted. Its use is not guaranteed for directly activating units
other than those specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
IMPORTANT ANNEX
Disconnect the power supply before handing the unit.
In compliance with the European Directive low‐voltage electrical equipment, we hereby inform
users of the following requirements:
• For units which are permanently connected, an easily accessible circuit‐breaker device must be
built into the wiring system.
• This unit must always be installed in a vertical position and firmly fixed to the structure of the
building.
• This unit must only be handled by a specialised installer, by his maintenance staff or by a duly
trained operator.
• The instruction manual for this unit must always remain in the possession of the user.
• Terminals of maximum section 3,8mm2 must be used for the power supply connections.
• Use time delayed fuses.
9