Technical Characteristics; Installation And Connections - Alcad CCA-200 Mode D'emploi

1247004‐GB_v1.1
TECHNICAL CHARACTERISTICS
Frequency
Coding
Memory
Events
Number of relays
Anti‐panic function
Alarm function
Power supply
Relay contacts
Standby / op. consumption
Battery
Access control output (Max. 2 readers without external
power supply)
Op. temperature
Watertightness
Size
Box dimensions
INSTALLATION AND CONNECTIONS
Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the cables
through the bottom of the unit. Connect the power cables to the terminals marked in the mother
board, as indicated. Fix the unit front to the rear part using the screws supplied.
OPERATION
The lights on the screen blink to indicate correct power supply to the equipment.
On receiving a code the equipment checks if it is in the memory, activating the programmes
relay(s).
If the equipment code is not stored in the memory, the equipment will not perform any action, and
the message "no" will be displayed on the screen.
MENUS
To access the menu, press any key and enter the password using the
number, changes digit, C confirms password. If the password is incorrect, the message "Err" is
displayed on screen and the equipment emits a bleep.
The manufacturer set password is written on a sticker located on the memory card.
The menus that will be displayed are: Mod1 (basic mode), Mod2 (advanced mode), ‐‐‐‐ (exit).
are used to change mode. To confirm each option, press the C key.
Menu scrolling key
Menu scrolling key
C Menu accessing or option validating key
If no action is performed, the equipment exits the program automatically after a period of 60
seconds and emits two short beeps.
DISPLAY DESCRIPTION
Mod1 Basic mode: Allows programming in multi‐channel mode and individual cancellations.
Mod2 Advanced mode: Allows complete management of the unit: programming (F.1),
cancellations (F.2), time configuration (F.3) and relay configuration(F.4).
CCA‐200
868,35MHz
High security rolling code
500 codes
1000 event card (optional)
1 (expandable to 4)
Configurable on relay 4
Only available on proximity equipment
with alarm function
230Vac ±10%
1A
23mA / 42mA
CR 2032 3Vdc
BUS‐L
‐20ºC to +85ºC
IP54 (with glands IP65)
115x95x35mm
140x220x55mm
6
keys. increases