Publicité
Les langues disponibles
Les langues disponibles
Fig.0:
(81) Main body; (79) Rear stabiliser
bar; (60) Front stabiliser bar; (9), (10),
(11), (13) Covers; (24) Saddle; (31)
Saddle post; (34) Handlebar post; (1)
Monitor; (21) Handlebar; (5) iPad
support tube; (2) iPad support; (48)
Pedals; (89) Mains transformer.
Bag of screws containing: (18) Screw
M5x35; (19) Screw M4x15; (6) Flat
washer
D19xD8,5x1,5;
washer
D12,7xD8,3x2,2;
M8x20; Wrenches.
2. Position the machine's front stand
on the front stabiliser bar (60), as
shown in Fig.1, insert the bolts (8), fit
the washers (7), (6) and then tighten
securely.
3. Position the rear stabiliser bar with
wheels (79) as shown in Fig.1, insert
the bolts (8), fit the flat washers (7),
(6) and tighten securely.
2.- ATTACHING THE SADDLE.-
Attach the saddle (24) to the upper
(25) and lower (26) fix sheet and
secure it using the screws (29), (30),
the nuts (28) and the bushings (27),
Fig.2A. The shorter screw (29) should
be placed in the front.
Insert the saddle post (24) into the
hole on the main body (81) and tighten
the clamp (40), Fig.2.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the clamp (40) slightly, Fig.2,
move
the
saddle
comfortable for doing exercise and
then tighten the clamp (40) securely.
3.- FITTING THE HANDLEBAR.-
Bring the handlebar post (34) close to
the main body (81) and connect the
(7)
Spring
(8)
Bolt
to
a
position
upper computer cable (15) with the
lower computer cable (84), Fig.3.
Insert the handlebar post (34) into the
hole on the main body, Fig.3. Position
it correctly and then tighten the knob
(36) by turning it clockwise.
Attach the handlebar (21) to the
handlebar post (34) using the fix sheet
(16), the screws (17), the washers (7),
Fig.4.
There
are
handlebar.
suitable for the user before the next
assembly step.
Connect the cable (15) with (20L) and
(20R), Fig.4.
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Position the handlebar (34) at a
comfortable
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (36) securely, Fig.3.
4.- FITTING THE PEDALS.-
The assembly instructions for the pedals
must be followed to the letter, fitting
these incorrectly could damage the
screw thread on either the pedal or the
crank. Right and left refer to the position
that the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (48R) marked with
the letter (R), screws onto the right-hand
crank (50R), also marked with an (R), in
a clockwise direction. Tighten securely,
Fig.4.
The left-hand pedal (48L) marked with
the letter (L), screws onto the left-hand
crank (50L), also marked with an (L), in
14
two
positions
Check
which
distance
for
of
the
one
is
doing
Publicité
