Briteq COB SLIM100-RGB Mode D'emploi page 9

ENGLISH
DMX ADDR
Used to set the desired DMX-address.
 Press the [MODE] button until the display shows [DMX ADDR].
 Press the [ENTER] button: the DMX value can now be changed
 Use DOWN and UP buttons to select the desired DMX512 address. The last occupied DMX-address is
also shown: this makes it easier to set the address of the next unit in the chain.
 Once the correct address shows on the display, press the [ENTER] button to save it.
Note: on RDM-compatible controllers this option can also be remotely set.
CH. MODE
Used to set the desired channel mode.
 Press the [MODE] button until the display shows [CH MODE].
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 [CH:03] : R, G & B can be set separately, no master dimmer.
 [CH:04LC] : R, G & B can be set separately, with combined strobe + master dimmer on CH4.
 [CH:04+] : R, G & B can be set separately, with master dimmer on CH4. (no strobe)
 [CH:06] : R, G & B can be set separately, with separate master dim, strobe and color effect channels.
 Once the correct option shows on the display, press the [ENTER] button to save it.
Remark: on RDM-compatible controllers this option can also be remotely set.
SLAVE MODE
Used to set the projector as slave in a master/slave setup.
 Press the [MODE] button until the display shows [SLAVE MODE].
 Press the [ENTER] button
SOUND SENS
Used to set sensitivity of the internal microphone, so the projector reacts in the best condition when
in sound controlled mode.
 Press the [MODE] button until the display shows [SOUND SENSE].
 Press the [ENTER] button: the value can now be changed
 Use DOWN and UP buttons to select the desired sensitivity. (00 = lowest sensitivity, 31=highest
sensitivity)
 Once you have set the desired sensitivity, press the [ENTER] button to save this new value.
AUTO RUN
Used to run all the internal automatic programs automatically.
 Press the [MODE] button until the display shows [AUTO RUN].
 Press the [ENTER] button. [SP] starts to blink on the display: you can now set the speed of the program
 Use DOWN and UP buttons to select the desired speed (01=slowest, 99= fastest speed)
 Press the [ENTER] button. [R] starts to blink on the display: you can now set the repetition rate
 Use DOWN and UP buttons to select the number of times each program should be repeated before to go
to the next step (01 to 99 times)
 Press the [ENTER] button to confirm your settings
IR-REMOTE
Used to set the wireless remote function on/off.
 Press the [MODE] button until the display shows [W.REMOTE].
 Press the [ENTER] button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 OFF
The unit does not accept commands from the supplied remote controller.
 ON
The unit can only be controlled by the supplied remote controller.
 Once the correct option shows on the display, press the [ENTER] button to save it.
BRITEQ
®
7/67
OPERATION MANUAL
COB SLIM100-RGB