Temp Mode - simatherm IH 210 Mode D'emploi

5.3

Temp mode

• If the main display shows 't', press MODE to select TEMP MODE.
The main display shows °C or °F in TEMP MODE.
• The selected temperature is shown on the main display. The default
temperature for bearings is 110°C (230°F). If a different temperature is
desired, press UP or DOWN to adjust the temperature in steps of 1°.
It may be desirable to heat bearings to temperatures above 110°C
(230°F) for increased mounting time. Consult the bearing specifications
to determine the maximum permitted temperature. Always ensure
the bearing doesn't lock due to an excessive expansion of the inner
ring compared to outer ring. See section 5.8.
• Spherical Roller Bearings (SRBs) are subjected to a special
heat treatment. These bearings can be operated at temperatures as
high as 200°C (392°F). Heating these bearings above 110°C (230°F) will
not cause any damage as long as the bearing is still able to rotate. For
other bearings, a temperature of 125°C (257°F) must not be exceeded
unless otherwise specified.
• Press POWER to select the power level. Use the guidelines in
section 5.8 to determine the correct power setting.
• Press START/STOP to start the heater. The main display shows the
current temperature of the workpiece.
• When the selected temperature has been reached, the heater
demagnetises the workpiece, switches off, and generates an
acoustic signal for 10 seconds or until START/STOP is pressed.
• Press START/STOP to stop the heater.
• Remove the workpiece with proper handling equipment.
• If the workpiece remains on the heater, the heater will start again
when the temperature of the workpiece drops 10°C (18°F). Press
START/STOP to stop the heater and demagnetise the workpiece.
• The IH 210 is now ready to heat another workpiece with the
same settings.
© simatec ag Induction Heater IH 210 25