Distinguishing Feature; Technical Description; Components - simatherm IH 210 Mode D'emploi

1.3

Distinguishing feature

The distinguishing feature of the IH 210 induction heater is the location
of the workpiece at the same position on the core as the inductive coil.
This design improves efficiency, resulting in less power consumption and
faster heating, which reduces the cost to heat each bearing.
2 Description
The operation of the heater is controlled by the internal electronics in
either of two modes. The operator can either select the desired
temperature of the bearing in TEMP MODE or set the length of time
that the bearing will be heated in TIME MODE. The power level can be
adjusted in steps of 20% for slower heating of sensitive workpieces
(for example, bearings with C1 or C2 clearance).
2.1

Components

The IH 210 induction heater contains a U-shaped iron core with an
inductive coil surrounding one of the vertical supports. Internal electronics
control the operation of the heater. A sliding yoke on the top of the
vertical supports allows the workpiece to be placed onto the heater.
To accommodate smaller workpieces, a small yoke is also provided.
A temperature probe is also included with the heater. Heat-resistant
gloves are also included.
© simatec ag Induction Heater IH 210 21