AgfaPhoto AS1150 Manuel D'utilisation page 39

Problems
The control lamp STATUS flashes quickly, scan-
ning not possible / memory card is not recognised
Transfer to a digital photo frame is not working
Solutions
• Check whether you have used a compatible
memory card and whether you have inserted
the memory card correctly.
• Remove the memory card and insert it into the
slot again
• Switch any active read-only options on the
memory card off.
• Make sure the memory card is not damaged.
• Check the available memory space on the mem-
ory card. If the available space is less than 1MB,
the scanning process cannot take place
• Check the file format of the memory card
Only memory cards in the FAT16 or FAT32 file
format can be used.
• Check whether the next document was insert-
ed too quickly.
When scanning several documents, wait until
the data transfer of the first scan has ended
(status lamp continuously on)
• Check the document length (see technical data)
• This function is only available with certain pho-
to frames.
EN
11