Scanning; Loading Photos - AgfaPhoto AS1150 Manuel D'utilisation

Scanning

EN

Loading Photos

Loading Documents
You can insert different types of document into
your device. Follow the specifications in the tech-
nical data.
You can scan documents using the protective
cover to avoid the photo or document being dam-
aged by scratches or creases.
Notice
Scanning documents with the protective
cover
If smaller documents are scanned using
the protective cover, in certain cases,
the automatic cutting off function does
not function properly. Either important
parts of the image are cut off or too
much edge remains around the docu-
ment. In this case, scan the documents
without using the protective cover.
Scanning documents with the protective cover
Unsuitable Documents!
No paper clips, staples, fixing pins or
similar may be retained on the docu-
ments.
1 Insert a document into the document feeder
text side up and the top of the page facing the
h key.
2 Align the document to the left hand edge.
3 Fix the document in place using the document
guide on the right hand side. The document
guide should lightly touch the documents.
4 Push the document horizontally as far into the
document feeder until it is automatically fed
into the scanner and the scanning process is
started. Ensure you do not bend the document.
The control lamp h flashes during the scan-
ning process.
Document Jam!
Do not insert documents into the
feeder whilst the device is scanning.
This can lead to a paper jam.
6
CAUTION!
DANGER!
5 Wait until the control lamp h and STATUS
are no longer flashing and STATUS is contin-
ually on. This means that the scanning process
is completed and the data was saved onto the
memory card.
DANGER!
Document Jam!
Wait until both control lamps are no
longer flashing before you insert the
next document in order to prevent a
document jam.
6 The file name is assigned according to the DCF
(Design Rule for Camera File System) standard.
Notice
Stand-by Mode
If the scanner has not been used for
approx. 15 minutes, it automatically
switches off.
Using the protective cover
1 Open the protective cover and insert the docu-
ment with the printed side facing up.
2 Lay the protective cover into the document
feeder with the printed side facing upwards,
the closed side of the page (black lines) for-
ward and the page header in the direction of
the h button.
3 Slide the protective cover horizontally as far
into the document feeder until it is automati-
cally fed into the scanner and the scanning
process is started. Ensure you do not bend the
document. The control lamp h flashes during
the scanning process.