Power Cycling - AgfaPhoto AS1150 Manuel D'utilisation

Power Cycling

If a problem occurs that cannot be corrected with
the instructions in this user manual (see also the
EN
help below), follow the steps given here.
Problems
The device cannot be switched on
The device feels warm
Lines are present on the scanned picture or the im-
age is not sharp
With scanned images, parts of the image are cut
off.
The document is stuck in the feeder
10
1 Press the reset button on the underside of the
device with a straightened paper clip.
2 If the problems repeats, please contact our
technical customer service or your retailer.
Solutions
Check that power supply or the USB cable is con-
nected to the device properly.
• After a certain period of operation, the surface
reaches approx. 30°C to 45 °C. This is normal.
If an unusual smell comes from the device or
the surface becomes too hot, disconnect the
scanner immediately from the power supply
and/or the computer / digital photo frame.
• Check whether the document is dirty or
scratched.
• Check whether the protective cover used is
dirty or scratched.
• Clean and calibrate the scanner if it has not
been used for a longer period.
• The scanner is equipped with a function for au-
tomatic cutting off of black edges. With small
images, the image is only saved without the
edge.
When using this function, cutting off of impor-
tant picture information can occur with images
with a black background (e.g. night shot).
In this case, rotate the image and scan it again.
Press the button h.
•
The document is automatically ejected.