Machine Certification - CAMPAGNOLA GSM EL TORO K EVOLUTION Manuel D'utilisation Et D'entretien

IMPORTANT!
To properly identify the tool, refer to the type, serial number and year of manufacture shown on the identifica-
tion plate and quote them to Campagnola Srl for any service request.
IMPORTANT!
The CE marking is unique and it certifies the conformity of the product with the machinery directive and the
other applicable directives in compliance with the conditions prescribed and shown in this manual.
In case of a "composite" machine/tool, a CE plate/label which identifies the type of tool (e.g. ATRA.xxxx)
composing the composite machine/tool is affixed to the product.
IMPORTANT!
The customer is in charge of checking the integrity of the CE plate/label.
The user must replace the CE and/or warning plates which become illegible due to wear.
It is strictly forbidden to remove the plates/labels on the machine/tool. Campagnola S.r.l declines any respon-
sibility on the safety of the machine/tool in case of non-compliance with this prohibition.

Machine certification

Directive 2006/42/EC contains the conditions according to which the machine may be used in the European Union
market.
The machine was designed, built and tested in compliance with the following Community regulations:
• Machinery Directive 2006/42/EC concerning the approximation of the laws of the member states relating to ma-
chinery.
• Technical standards listed in the declaration of conformity.
The manufacturer must place the machine on the market equipped with and accompanied by:
 CE Marking
 EC Declaration of conformity
 Instruction and warning manual
Below is a facsimile of the Declaration of conformity supplied with the machine.
Page 24
Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 04/03/2022