YORKVILLE DJM806 Manuel De L'utilisateur page 11

RACK MOUNTING (applies to DJM806 only)
To rack-mount the DJM806 you will need to purchase the accessory RK812 rack ears.
Then, simply remove the three screws holding each of the DJM-806's two end moldings
in place and use the screws to mount the rack ears to the sides of the mixer.
GENERAL OPERATING INSTRUCTIONS
1. Connect the AC power cord to a 120Volt AC grounded power outlet (220 to 240
Volts in export units).
2. Switch on the POWER and turn the MAIN and MONITOR MASTER controls
to OFF for now.
3. Connect low, or high impedance microphones to either the 3-pin XLR or 1/4 -
inch segments of the MIC 1, 2, and/or 3 inputs.
4. Connect stereo sources to CH 1, 2, 3 with RCA-ended patch cords. Now set the
input selector buttons for the inputs you are using.
5. Using heavy-gauge speaker cables (see under SPEAKER CONNECTIONS)
connect one 4 Ohm, or two 8 Ohm speakers to each channel on the back panel.
6. During a sound check, set the MAINS master at "7" (a good getting-started
setting) then adjust the channel GAIN and EQ controls, also the level faders as
required for the right basic mix and sound level. See under GAIN CONTROL and
CUE BUTTON for tips on setting the GAIN.
7. Still during the soundcheck, connect your headphones to the PHONES jack and turn
up the PHONES level. Now you are ready to listen to the main mix or check out CUE'd
channels or effects (see under the channel CUE and effects CUE sections).
8. Turn up the EFX send controls on those channels you wish to have effects (see
under EFFECTS CLIP LED for more on this). Now you can kill the effects sound
through the main speakers by punching the MAIN EFFECTS button into the "up"
position, then listen to the effects through the headphones by sliding the
HEADPHONE CROSSFADER to CUE and depressing the EFFECTS CUE button (the
LED will come on). Now SELECT and MODIFY the effects via those controls then
punch in the MAIN EFFECTS button when you wish to insert effects into the main
program.
9. Adjust the graphic EQ as required. Always use an EQ sparingly. Remember,
exaggerated EQ settings cost you power headroom and clarity when the
volume gets pumped.