Belkin F5D9630-4 Manuel De L'utilisateur page 29

Manually Configuring your Router
2–100 (99 computers). If you want to change this number, you
can do so by entering a new starting and ending IP address and
clicking on "Apply Changes". The DHCP server can assign 100 IP
addresses automatically. This means that you cannot specify an
IP address pool larger than 100 computers. For example, starting
at 50 means you have to end at 150 or lower so as not to exceed
the 100-client limit. The starting IP address must be lower in
number than the ending IP address.
5. Lease Time
Lease time is the length of time the DHCP server will reserve
the IP address for each computer. We recommend that you
leave the lease time set to "Forever". The default setting is
"Forever", meaning that any time a computer is assigned an IP
address by the DHCP server, the IP address will not change
for that particular computer. Setting lease times for shorter
intervals, such as one day or one hour, frees IP addresses after
the specified period of time. This also means that a particular
computer's IP address may change over time. If you have set any
of the other advanced features of the Router, such as DMZ or
client IP filters, these are dependent on the IP address. For this
reason, you will not want the IP address to change.
6. Local Domain Name
The default setting is "Belkin". You can set a local domain name
(network name) for your network. There is no need to change this
setting unless you have a specific advanced need to do so. You
can name the network anything you want such as "MY NETWORK".
27 27
1
2
3
4
5
6
7
8
9
10
12